Anne’s Creative Threads

This week I have been working on this gecko wall hanging, using the same fabrics as I used in my  a previous design but this time the wall hanging is embellished with needle lace leaves and the geckos are machine satin stitched with a hand dyed variegated cotton thread.

I made the needle lace leaves using a technique I learnt in an online course at Quilt University: ‘Machine Embellished Surfaces’ with  Susan Brittingham.

The leaves are first drawn out onto dissolving stabilizer with a permanent pen and then layered in an embroidery hoop with organza. Then using a free motion foot and the feed dogs lowered you stitch round the outline of the leaves and veins using a straight stitch. For these leaves I used a variegated rayon thread in both the bobbin and needle.

Detail showing the veins stitched first.

Detail showing the veins stitched and then the outline of the leaf. After the outlines are stitched you remove the fabric and stabilizer from the hoop and trim away the organza being careful to trim closely but not so close that the fabric will fray when you do the next stitching.

Next using a free motion zig zag stitch and the organza on top you stitch over the straight stitch outlines using a narrower stitch for the veins and a wider one for the outlines.

Once all the leaves are stitched you trim away the excess stabilizer and then rinse the leaves to remove the rest.

The completed leaf ready to be stitched onto the design.

 The finished design.